I reached out to Camco regarding a weld-on installation of the bushings for the Gen-Turi RV Generator Exhaust System # CAM44461. According to my contact, this is a perfectly acceptable way to install the system. When possible, welding will always outperform something like the clamps that are included when performed by a professional. That would be the most secure way to install this and remove any need for concern. view full answer...
As long as you're hooked up to the sewer there is no reason you can't leave the gray tank open with the SewerSolution Macerator System for RV Waste Tanks - Bayonet Fitting and 4-in-1 Adapter - 10' Item # SS01 since it's only liquids. The black tank shouldn't be left open continuously as solids can build up in the tank if the liquids are continuously draining. view full answer...
To have the back-up camera on and switch to the side cameras when you use your turn signals using the Rear View Safety Backup Camera System # RVS-062710, you will want to wire the back-up camera to the running lights and then run the side cameras to the turn signals using the trigger wires.
This should cause your back-up camera to remain on when the running lights are on and then when the turn signals receive power, the trigger wire will turn that camera on the screen. When the turn signal... view full answer...
In regards to the SumoSprings Solo Custom Helper Springs part # SSR-130-47, the amount of contact or engagement will vary by application and we unfortunately cannot inform of this for any one particular application since there are so many variables. That said, typically for the cab and chassis model springs you'll want them to engage just slightly with the weight vehicle. If you have a gap you can fill this with the included spacer until you make contact with the axle. That said, it's okay... view full answer...
I spoke with my contact at Camco regarding your RV Power Defender Circuit Analyzer # CAM55312. He said that if the blue surge protector light is no longer illuminating on your unit then it has experienced a surge episode (and protected your RV!). This may have happened with your 30 amp home outlet or it could have happened the previous time you used the analyzer at a campsite. Since this particular model provides one-time-event protection, it is no longer able to provide surge protection... view full answer...
There is no video for a 2020 Thor Vegas 24.1; for your other question you said rear stabilizer so I'm not sure if you meant steering stabilizer or rear anti-sway bar, and there is drilling for the Roadmaster Rear Anti-Sway Bar # RM-1139-117, but no drilling is required to install the Roadmaster Exact Center Steering Stabilizer # RM47MR.
I have added a cut out from the directions that show where the drilling is needed for the Roadmaster Rear Anti-Sway Bar # RM-1139-117. view full answer...
TPMS system like the TireMinder i10 TPMS for RVs and Trailers # TM29FR are designed to be used with the included signal booster. This ensures the greatest accuracy and reliability when it comes to the readings from the sensors.
The repeater extends the signal and also improves the signal strength to cut through signal interference that comes from surrounding automobiles. According to the manufacturer, the signal booster should be installed on any system that includes it.
I have attached... view full answer...
No, there is not a clip that would have fallen off. The Solera fabrics have a channel that slides into the roller bars to secure the fabric in place. I have included a video from the Solera 10' Replacement Awning Fabric # LCV000334335 that goes over the installation of Solera awning fabric and shows what holds it in place. That part begins around the 6:20 mark of the video. view full answer...
Go To Results